Alcatel-Lucent OmniSwitch 6250 - Show Ipv6 Rip

IPv6 Commands
page 30-80 OmniSwitch 6250 CLI Reference Guide November 2009
show ipv6 rip
Displays the RIPng status and general configuration parameters.
show ipv6 rip
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> show ipv6 rip
Status = Enabled,
Number of routes = 10,
Route tag = 0,
Update interval = 30,
Invalid interval = 180,
Garbage interval = 120,
Holddown interval = 0,
Jitter interval = 5,
Triggered Updates = All Routes,
output definitions
Status RIPng protocol status (enabled or disabled).
Number of routes Number of RIPng routes in Forwarding Information Base (FIB).
Route tag Route tag value for RIP routes generated by the switch. Valid range is
0-65535. Default is 0.
Invalid interval Invalid Timer setting, in seconds.
Garbage interval Garbage Timer setting, in seconds.
Holddown interval Holddown Timer setting, in seconds.
Jitter interval Jitter setting.
Triggered updates Triggered Updates setting (All Routes, Updated Routes, and None).