IPv6 Commands
page 30-68 OmniSwitch 6250 CLI Reference Guide November 2009
ipv6 rip garbage-timer
Configures the RIPng garbage timer value. When a route in the RIB exceeds the configured Invalid Timer
Value, the route is moved to a “Garbage” state in the the RIB. The garbage timer is the length of time a
route will stay in this state before it is flushed from the RIB.
ipv6 rip garbage-timer seconds
Syntax Definitions
seconds Time, in seconds, that a route will remain in the RIPng Routing Table
before it is flushed from the RIB. Valid range is 0 - 180.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the ipv6 rip invalid-timer command to set the Invalid Timer Value.
Examples
-> ipv6 rip garbage-timer 180
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaProtocolripng
alaRipngGarbageTimer
parameter default
seconds 120
ipv6 rip invalid-timer Configures the amount of time a route remains active in RIB before
being moved to the "Garbage" state.
ipv6 rip holddown-timer Configures the amount of time a route is placed in a holddown state.
To Next Page
Loading...
