IP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 29-77
ip dos scan decay
Sets the decay speed of the port scan penalty value for the switch when calculating DoS attacks.
ip dos scan decay decay_value
Syntax Definitions
decay_value The decay value amount for reducing the port scan penalty. This value
can be any non-negative integer.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
The port scan penalty value is reduced every minute by dividing by the amount set in using this command.
For example, if the decay value is set to 10, every minute the total port scan penalty value is divided by
10.
Examples
-> ip dos scan decay 10
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaDoSConfig
alaDoSPortScanDecay
parameter default
decay_value 2
ip dos scan threshold Sets the threshold for the port scan value, at which a DoS attack is
recorded.
show ip dos config Displays the configuration parameters of the DoS scan for the
switch.
To Next Page
Loading...
