Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-43
show interfaces flow control
Displays interface flow control wait time settings.
show interfaces [slot[/port[-port2]]] flow [control]
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
control Optional command syntax. It displays the same information as show
interfaces flow.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If no slot/port numbers are entered, flow control wait time settings for all slots/ports on the switch are
displayed.
• You can display a specific interface by entering the slot and port number, a range of ports by entering a
slot and a range of ports, display all interfaces in a slot by entering the slot number, or display all inter-
faces as described above.
Examples
-> show interfaces 3/20-24 flow
Slot/Port Active Wait time(usec) Cfg-Flow Cfg-Cross
-----------+--------+----------------+--------+-----------
3/20 - 0 Pause MDIX
3/21 - 0 Pause MDIX
3/22 - 0 Pause MDIX
3/23 - 0 Go MDIX
3/24 - 0 Go MDIX
output definitions
Slot/Port Interface slot and port number
Active Interface status.
Wait time Flow control wait time, in microseconds.
Cfg-Flow Flow control status (Pause or Go).
Cfg-Cross The user-configured cross-over setting (Auto, MDI, or MDIX).
To Next Page
Loading...
