Source Learning Commands
page 18-18 OmniSwitch 6250 CLI Reference Guide November 2009
show mac-address-table aging-time
Displays the current aging time value.
show mac-address-table aging-time
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The MAC Address Table aging time applies to static MAC addresses that were defined using the time-
out parameter (see page 18-2) and to dynamically learned MAC addresses.
• Note that the aging time is the same for all VLANs because it is not configurable on a per-VLAN basis.
The aging time value on this platform is a global parameter that applies to all VLANs.
Examples
-> show mac-address-table aging-time
Mac Address Aging Time (seconds) = 300
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
slMacAddressAgingTable
slMacAgingValue
show mac-address-table Displays Source Learning MAC Address Table information.
show mac-address-table count Displays Source Learning MAC Address Table statistics.
To Next Page
Loading...
