GVRP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 23-31
show gvrp timer
Displays the timer values configured for all the ports or a specific port.
show gvrp timer [[join | leave | leaveall] {linkagg agg_num | port slot/port}]
Syntax Definitions
join Displays the Join timer value.
leave Displays the Leave timer value.
leaveall Displays the LeaveAll timer value.
agg_num The number corresponding to the aggregate group.
slot/port The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
Defaults
By default the timer values configured on all the ports are displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the join, leave, or leaveall parameter with this command to view the specific timer values config-
ured on all the ports.
• Use the agg_num or slot/port parameter with this command to display the timer values configured for a
specific port.
Examples
-> show gvrp timer
Legend : All timer values are in milliseconds
Port Join Timer Leave Timer LeaveAll Timer
--------+--------------+--------------+---------------
1/1 600 1800 30000
1/2 600 1800 30000
1/3 600 1800 30000
1/4 600 1800 30000
1/5 600 1800 30000
1/6 600 1800 30000
1/7 600 1800 30000
1/8 600 1800 30000
1/9 600 1800 30000
1/10 600 1800 30000
1/11 600 1800 30000
1/12 600 1800 30000
1/13 600 1800 30000
1/14 600 1800 30000
1/15 600 1800 30000
To Next Page
Loading...
