Learned Port Security Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 19-23
show port-security shutdown
Displays the amount of time during which source learning can occur on all LPS ports.
show port-security shutdown
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The source learning time limit is a switch-wide parameter that applies to all ports that have LPS
enabled.
• If the shutdown time is set to zero, then a source learning time limit is not active on LPS ports.
• Note that source learning of configured authorized MAC addresses is still allowed after the LPS time
limit has expired; however, all learning is stopped if the number of MAC addresses learned meets or
exceeds the maximum number of addresses allowed, even if the LPS time limit has not expired.
Examples
-> show port-security shutdown
LPS Shutdown Config = 2 min
Convert-to-static = DISABLE
Remaining Learning Window = 110 sec
Release History
Release 6.6.1; command was introduced.
output definitions
LPS Shutdown Config The configured amount of time during which the LPS port can learn
new MAC addresses.
Convert-to-static Indicates whether or not dynamic MACs are converted to static MACs
(enabled or disabled). Configured through the
port-security shutdown command.
Remaining Learning Window The remaining amount of time during which the LPS port can learn
MAC addresses.
To Next Page
Loading...
