Port Mobility Commands
page 21-22 OmniSwitch 6250 CLI Reference Guide November 2009
vlan port default vlan restore
Enables or disables default VLAN restore for a mobile port. Use this command to specify if a mobile port
should retain or drop its dynamic VLAN assignments after all MAC addresses learned on that port have
aged out.
vlan port slot/port default vlan restore {enable | disable}
Syntax Definitions
slot/port The slot number for the module and the physical mobile port number on
that module (e.g., 3/1 specifies port 1 on slot 3). To enter multiple slots
and ports in a single command, use a hyphen to specify a range of ports
(e.g., 3/1-16) and a space to specify multiple slots (e.g., 3/1-16 5/10-20
8/2-9).
enable Enable default VLAN restore for the specified mobile port. VLAN
assignments are dropped when port traffic ages out.
disable Disable default VLAN restore for the specified mobile port. VLAN
assignments are retained when port traffic ages out.
Defaults
By default, VLAN restore is enabled on mobile ports.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If a hub is connected to a mobile port, enabling default VLAN restore on that port is recommended.
• If a VLAN port rule exists for a mobile port, it will remain a member of the port rule VLAN even if
default VLAN restore is enabled for that port.
• When a mobile port link is disabled and then enabled, the port is always returned to its configured
default VLAN. Switch ports are disabled when a device is disconnected from the port, a configuration
change is made to disable the port, or switch power is turned off.
Examples
-> vlan port 3/1 default vlan restore enable
-> vlan port 5/2 default vlan restore disable
-> vlan port 6/1-32 8/10-24 9/3-14 default vlan restore enable
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
