IP Multicast VLAN Commands
page 42-2 OmniSwitch 6250 CLI Reference Guide November 2009
vlan ipmvlan
Creates an IP Multicast VLAN.
vlan ipmvlan ipmvlan-id [{enable | disable} | [{1x1 | flat} stp {enable | disable}]] [name name-string]
[svlan]
no vlan ipmvlan ipmvlan-id [-ipmvlan-id2]
Syntax Definitions
ipmvlan-id Specifies the IP Multicast VLAN number. The valid range is 2–4094.
enable Enables IPMVLAN.
disable Disables IPMVLAN.
1x1 Specifies that the switch is running in the 1x1 Spanning Tree mode.
flat Specifies that the switch is running in the Flat Spanning Tree mode.
stp enable Enables Spanning Tree for the specified IPMVLAN.
stp disable Disables Spanning Tree for the specified IPMVLAN.
name-string Alphanumeric string up to 32 characters. Use quotes around the string if
the name contains multiple words with spaces between them (for exam-
ple, “Alcatel-Lucent VLAN”).
svlan Tags the IPMVLAN to be used in VLAN Stacking environment.
ipmvlan-id2 Th last IPMVLAN number in a range of IPMVLANs that you want to
configure.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to delete a single or multiple IPMVLANs. If the specified IPMV-
LAN(s) does not exist, an error message will be displayed.
• If ipmvlan-id does not exist or if ipmvlan-id exists as VLAN Stacking VLAN or Standard VLAN, an
error message will be displayed.
• Use the svlan parameter to specify that the IPMVLAN should be used in the VLAN Stacking environ-
ment.
• The default mode of the IPMVLAN is the Enterprise mode.
parameter default
enable | disable enable
To Next Page
Loading...
