Ethernet Port Commands
page 20-86 OmniSwitch 6250 CLI Reference Guide November 2009
show interfaces hybrid collisions
Displays interface collision information (e.g., number of collisions, number of retries) for combo ports.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} collisions
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
fiber Specifies that statistics for the SFP port(s) will be displayed.
copper Specifies that statistics for the copper RJ-45 port(s) will be displayed.
Defaults
If a specific slot or slot/port number is not entered with this command, the information for all switch
combo ports is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Enter a slot and port number or a range of port numbers to display collision information for a specific
combo port or a range of combo ports.
• Enter a slot number to display information for all combo ports on a specific slot.
• These counters do not apply to Gigabit Ethernet traffic.
Examples
-> show interfaces 1/25 hybrid copper collisions
01/25,
Rx Collisions = 6.56E18, Rx Single Collision = 345464364,
Rx Multiple Collisions = 6325235326, Rx Excessive Collisions = 5.65E19
To Next Page
Loading...
