IP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 29-91
show ip route-map
Displays the IP route maps configured on the switch.
show ip route-map [route-map-name]
Syntax Definitions
route-map-name The name of the specific route map.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
If the route-map-name is not specified in this command, all the route maps are displayed.
Examples
-> show ip route-map
Route Maps: configured: 1 max: 200
Route Map: Route_map1 Sequence Number: 50 Action permit
match ip address 10.0.0.0/8 redist-control all-subnets permit
set metric 100 effect replace
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
