Power over Ethernet (PoE) Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 4-7
lanpower maxpower
Specifies the maximum amount of inline power, in watts, allocated to all PoE ports in a specified slot.
lanpower slot maxpower watts
Syntax Definitions
slot The slot containing PoE ports on which the maximum amount of inline
power allowed is being allocated.
watts The maximum amount of inline power, in watts, allocated to all PoE
ports in the corresponding slot (37–225).
Defaults
Platforms Supported
OmniSwitch 6250-Enterprise Models
Usage Guidelines
• Before changing the maximum slot-wide power allowance, you must disable PoE for the slot via the
lanpower stop command. Once the new value is assigned, re-enable PoE for the slot via the lanpower
start command.
• To specify the maximum amount of inline power allocated to a single port, refer to the lanpower
power command on page 4-5.
• Note that the power value for the lanpower maxpower command is specified in watts (W); the related
command, lanpower power, is specified in milliwatts (mW).
Examples
-> lanpower 3 maxpower 200
Release History
Release 6.6.1; command was introduced.
parameter default
watts 225
To Next Page
Loading...
