CMM Commands
page 1-6 OmniSwitch 6250 CLI Reference Guide November 2009
copy running-config working
Copies the running configuration (RAM) to the working directory.
[configure] copy running-config working
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command is used to copy the changes made using the CLI commands from the running configura-
tion (RAM) to the working directory.
• This command is only valid if the switch is running from the working directory. Use the show
running-directory command to check from where the switch is running.
• This command performs the same function as the write memory command.
Note. The saved boot.cfg file will be overwritten if the takeover command is executed after the copy
running-config working or write memory commands, in an OmniSwitch set up with redundant CMMs.
Examples
-> configure copy running-config working
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
