SNMP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 10-27
show snmp trap filter
Displays the current SNMP trap filter status.
show snmp trap filter
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
To display a list of traps and their ID numbers, use the show snmp trap config command.
Examples
-> show snmp trap filter
ipAddress trapId list
-----------------------------------------+-----------------------------------
172.21.160.32 1 3 4
172.21.160.12 no filter
0300:0000:0000:0000:0211:d8ff:fe47:470b 4 5 6
0300:0000:0000:0000:0211:d8ff:fe47:470c no filter
Release History
Release 6.6.1; command was introduced.
Related Commands
output definitions
IPAddress IP address of the SNMP management station that recorded the traps.
TrapId List Identification number for the traps being filtered.
snmp trap filter Enables or disables SNMP trap filtering.
show snmp trap config Displays the SNMP trap information, including trap ID numbers, trap
names, command families, and absorption rate.
To Next Page
Loading...
