802.1AB Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 13-5
lldp reinit delay
Sets the time interval that must elapse before the current status of a port is reinitialized after a status
change.
lldp reinit delay seconds
Syntax Definitions
seconds The number of seconds to reinitialize the ports status after a status
change. The valid range is 1-10.
Defaults
Platforms Supported
OmniSwitch 6250 .
Usage Guidelines
The LLDP protocol must be enabled before using this command.
Examples
-> lldp reinit delay 4
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
lldpConfiguration
lldpReinitDelay
parameter default
seconds 2
lldp transmit delay Sets the minimum time interval between successive LLDPDUs trans-
mitted.
show lldp local -system Displays local system information.
To Next Page
Loading...
