IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-73
ipv6 rip triggered-sends
Configures the behavior of triggered updates.
ipv6 rip triggered-sends {all | updated-only | none}
Syntax Definitions
all All RIPng routes are added to any triggered updates.
updated-only Only route changes that are causing the triggered update are included in
the update packets.
none RIPng routes are not added to triggered updates.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If set to all, all routes are sent in the update, not just route changes, which increases RIPng traffic on
the network.
• If set to none, no triggered updates are sent, which can cause delays in network convergence.
Examples
-> ipv6 rip triggered-sends none
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaProtocolripng
alaRipngTriggeredSends
parameter default
all | updated-only | none updated-only
show ipv6 rip Displays RIPng status and general configuration information.
To Next Page
Loading...
