IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-39
ipv6 multicast querier-forwarding
Enables or disables MLD querier forwarding on the specified VLAN or on the system if no VLAN is
specified.
ipv6 multicast [vlan vid] querier-forwarding [{enable | disable}]
no ipv6 multicast [vlan vid] querier-forwarding
Syntax Definitions
vid The VLAN on which configuration is applied.
enable Enable MLD querier forwarding.
disable Disable MLD querier forwarding.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove an MLD querier forwarding entry on the specified VLAN
or on the system and return to its default behavior.
• If the MLD querier forwarding is already enabled on the system, then the VLAN configuration will
override the system's configuration.
• MLD querier forwarding refers to promoting detected MLD queriers to receive all IP multicast data
traffic.
Examples
-> ipv6 multicast querier-forwarding enable
-> ipv6 multicast querier-forwarding disable
-> ipv6 multicast querier-forwarding
-> ipv6 multicast vlan 2 querier-forwarding enable
-> ipv6 multicast vlan 2 querier-forwarding disable
-> ipv6 multicast vlan 2 querier-forwarding
-> no ipv6 multicast vlan 2 querier-forwarding
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable disable
To Next Page
Loading...
