RDP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 31-11
ip router-discovery interface advertisement-lifetime
Configures the maximum amount of time, in seconds, that router IP addresses advertised from the speci-
fied interface are considered valid. This value is set in the lifetime field of the advertisement packets trans-
mitted on the specified RDP interface.
ip router-discovery interface name advertisement-lifetime seconds
Syntax Definitions
name The IP interface name that was defined at the time the IP interface was
configured.
seconds The length of time, in seconds, that advertised IP addresses are consid-
ered valid by the receiving host. The range is the value set for the maxi-
mum advertisement interval to 9000.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The RDP interface advertisement lifetime value is not active unless RDP is enabled on the switch, and
the specified interface is also enabled.
• Do not specify an advertisement lifetime value that is less than the value specified for the maximum
advertisement interval. To set the maximum advertisement interval value, use the
ip router-discovery interface max-advertisement-interval command.
Examples
-> ip router-discovery interface Marketing advertisement-lifetime 2000
-> ip router-discovery interface Accounting advertisement-lifetime 750
Release History
Release 6.6.1; command was introduced.
parameter default
seconds 3 * maximum advertisement interval
To Next Page
Loading...
