Alcatel-Lucent OmniSwitch 6250 - Show Interfaces Hybrid Port

Ethernet Port Commands
page 20-90 OmniSwitch 6250 CLI Reference Guide November 2009
show interfaces hybrid port
Displays interface port status (up or down) for combo ports.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} port
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
fiber Specifies that the status of the SFP port(s) will be displayed.
copper Specifies that the status of the copper RJ-45 port(s) will be displayed.
Defaults
If a specific slot or slot/port number is not entered with this command, the port status for all switch combo
ports is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Enter a slot and port number or a range of port numbers to display information for a specific combo
port or a range of combo ports.
• Enter a slot number to display information for all combo ports on a specific slot.
Examples
-> show interfaces 1/25 hybrid fiber port
Slot/Port Admin Status Link Status Alias
----------+--------------+------------+----------------------------------------
1/25 enable down ""
Release History
Release 6.6.1; command was introduced.
output definitions
Slot/Port Interface slot and port number.
Admin Status Port status (enable/disable).
Link Status Operational status (enable/disable).
Alias Interface alias.