Port Mobility Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 21-31
show vlan port mobile
Displays current status of mobile properties for a switch port.
show vlan port mobile [slot/port]
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3). To enter multiple slots and
ports in a single command, use a hyphen to specify a range of ports
(e.g., 3/1-16) and a space to specify multiple slots (e.g., 3/1-16 5/10-20
8/2-9).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If a slot/port is not specified, then mobile properties for all ports are displayed.
• Note that the show vlan port mobile command only displays ports that are mobile or are eligible to
become mobile ports. For example, ports that are part of a link aggregate or are configured for 802.1Q
VLAN tagging are not included in the output of this command.
Examples
-> show vlan port mobile
cfg ignore
port mobile def authent enabled restore bpdu
+-----+------+----+--------+--------+--------+-----+
12/12 on 1 off on off off
12/13 off
12/14 off
12/15 on 10 on-8021x off on off
12/16 on 10 on-8021x on off on
output definitions
port The slot number for the module and the physical mobile port number
on that module.
mobile The mobile status for the port (on or off). If set to on, the port is mobile
and eligible for dynamic VLAN assignment. If set to off, the port is
non-mobile and remains only a member of its configured default
VLAN. Use the vlan port mobile to enable or disable mobility on a
port.
cfg def The configured default VLAN for the port, which is assigned using the
vlan port default command.
To Next Page
Loading...
