GVRP Commands
page 23-6 OmniSwitch 6250 CLI Reference Guide November 2009
gvrp maximum vlan
Configures the maximum number of dynamic VLANs that can be created by GVRP.
gvrp maximum vlan vlanlimit
Syntax Definitions
vlanlimit The maximum number of VLANs to be created by GVRP. The valid
range is 32–4094.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command can be used even when GVRP is not enabled on the switch. However, GVRP should be
enabled on the switch for creating dynamic VLANs.
• If the VLAN limit to be set is less than the current number of dynamically learnt VLANs, then the new
configuration will take effect only after the GVRP is disabled and enabled again on the switch. If this
operation is not done, the VLANs learnt earlier will be maintained.
Examples
-> gvrp maximum vlan 100
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaGvrpMaxVlanLimit
parameter default
vlanlimit 256
show gvrp configuration Displays the global configuration for GVRP.
To Next Page
Loading...
