Alcatel-Lucent OmniSwitch 6250 - Show Ip Rip Interface

RIP Commands
page 33-28 OmniSwitch 6250 CLI Reference Guide November 2009
show ip rip interface
Displays RIP interface status and configuration.
show ip rip interface [interface_name]
Syntax Definitions
interface_name The interface name.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Enter an IP address to view a specific interface. Enter the basic show ip rip interface command to show
status for all interfaces.
Examples
-> show ip rip interface rip-1
Interface IP Name = rip-1,
Interface IP Address = 11.11.11.1
IP Interface Number (VLANId) = 4,
Interface Admin status = enabled,
IP Interface Status = enabled,
Interface Config AuthType = None,
Interface Config AuthKey Length = 0,
Interface Config Send-Version = v2,
Interface Config Receive-Version = both,
Interface Config Default Metric = 1,
Received Packets = 154,
Received Bad Packets = 0,
Received Bad Routes = 0,
Sent Updates = 8
output definitions
Interface IP Name The IP Interface name.
Interface IP Address Interface IP address.
IP Interface Number Interface VLAN ID number.
Interface Admin Status The RIP administrative status (enabled/disabled).
IP Interface Status Interface status (enabled /disabled).
Interface Config AuthType The type of authentication that will be used for the RIP interface (None
or Simple).