IPv6 Commands
page 30-66 OmniSwitch 6250 CLI Reference Guide November 2009
ipv6 rip status
Enables or disables RIPng on the switch.
ipv6 rip status {enable | disable}
Syntax Definitions
N/A
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
RIPng must be loaded on the switch (ipv6 load rip) to enable RIP on the switch.
Examples
-> ipv6 rip status enable
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaProtocolripng
alaRipngProtoStatus
parameter default
enable | disable disable
ipv6 load rip Loads RIPng into memory.
show ipv6 rip Displays RIPng status and general configuration parameters.
To Next Page
Loading...
