Link Aggregation Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 12-19
lacp linkagg partner system priority
Configures the priority of the remote switch’s dynamic aggregate group to which the local switch’s aggre-
gate group is attached.
lacp linkagg agg_num partner system priority partner_system_priority
lacp linkagg agg_num no partner system priority
Syntax Definitions
agg_num The number corresponding to the dynamic aggregate group.
partner_system_priority The priority of the remote switch’s dynamic aggregate group to which
the local switch’s aggregate group is attached. Possible values are
0–65535.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the no form of this command to return to the priority value to its default.
Examples
-> lacp linkagg 3 partner system priority 65535
-> lacp linkagg 3 no partner system priority
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alclnkaggAggTable
alclnkaggAggNumber
alclnkaggAggPartnerSystemPriority
parameter default
partner_system_priority 0
lacp linkagg size Creates a dynamic aggregate group.
show linkagg Displays information about static and dynamic (LACP) aggregate
groups.
To Next Page
Loading...
