QoS Commands
page 38-48 OmniSwitch CLI Reference Guide November 2009
qos port default 802.1p
Configures the 802.1p value to be inserted in flows ingressing on an untrusted port.
qos port slot/port default 802.1p value
Syntax Definitions
slot/port The slot number and port number of the physical port.
value The priority value to be set. Values range from 0 (lowest priority) to 7
(highest priority).
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• By default untrusted ports will set the 802.1p bit to zero on incoming flows. Use this command to spec-
ify that a different 802.1p value should be applied to the flow.
• The default 802.1p value is not used if there is a matching QoS policy rule that sets the priority.
• Note that on the 802.1p bit for tagged packets received on untrusted ports is set with the default 802.1p
value, which is configured using the qos port default 802.1p command. If the packet is untagged,
however, then the DSCP bit is set with the default DSCP value, which is configured using the qos port
default dscp command.
Examples
-> qos port 3/1 default 802.1p 5
Release History
Release 6.6.1; command was introduced.
Related Commands
parameter default
value 0
qos apply Applies configured QoS and policy settings to the current configuration.
qos port Configures a physical port for QoS.
show qos port Displays information about QoS ports.
To Next Page
Loading...
