IP Commands
page 29-54 OmniSwitch 6250 CLI Reference Guide November 2009
clear arp-cache
Deletes all dynamic entries from the ARP table.
clear arp-cache
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This commands only clears dynamic entries. If permanent entries have been added to the table, they
must be removed using the no form of the ip service command.
• Dynamic entries remain in the ARP table until they time out. The switch uses the MAC Address table
timeout value as the ARP timeout value. Use the mac-address-table aging-time command to set the
timeout value.
Examples
-> clear arp-cache
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaIpClearArpCache
ip service Adds a permanent entry to the ARP table.
show arp Displays the ARP table.
To Next Page
Loading...
