Alcatel-Lucent OmniSwitch 6250 - Avoiding Split Stacks; Do Not Reload Non-Adjacent Switches Simultaneously; Be Sure a Redundant Stacking Cable is Installed at All Times

Network Time Protocol Commands
page 5-14 OmniSwitch 6250 CLI Reference Guide November 2009
show ntp client server-list
Displays a list of the servers with which the NTP client synchronizes.
show ntp client server-list
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> show ntp client server-list
IP Address Ver Key St Delay Offset Disp
================+===+=======+====+==========+=================+==========
198.206.181.70 4 0 2 0.167 0.323 0.016
Release History
Release 6.6.1; command was introduced.
output definitions
IP Address The server IP address.
Ver The version of NTP the server is using. Versions 3 and 4 are valid.
Key The NTP server’s public key. This must be accurate and the same as the
NTP server, or the client switch will not be able to synchronize with the
NTP server. A zero (0) means there is no key entered.
St The stratum of the server.
Delay The delay received from the server in its timestamp.
Offset The offset received from the server in its timestamp.
Disp The dispersion value received from the server in its timestamp.