Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-5
interfaces speed
Configures interface line speed.
interfaces slot[/port[-port2]] speed {auto | 10 | 100 | 1000 | 10000 | max {100 | 1000}}
Syntax Definitions
slot Slot number you want to configure.
port Port number of the interface you want to configure.
port2 Last port number in a range of ports you want to configure.
auto The switch will automatically set the line speed to match the attached
device (auto-sensing).
10 Sets the interface to 10 Mbps.
100 Sets the interface to 100 Mbps.
1000 Sets the interface to 1 Gigabit.
10000 Sets the interface to 10 Gigabit.
max 100 Sets the maximum speed to 100 megabits.
max 1000 Sets the maximum speed to 1000 megabits (1 Gigabit).
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• You can only configure one slot at a time. Repeat the command to configure additional slots.
• The auto option sets the speed to auto-sensing.
• Configuration changes made with the interfaces speed command on combo ports configured as either
forced fiber or preferred fiber will only be made on the SFP fiber ports and not to the copper RJ-45
ports. See the interfaces hybrid speed command for more information.
• Configuration changes made with the interfaces speed command on combo ports configured as either
forced copper or preferred copper will only be made on the copper RJ-45 ports and not to the SFP fiber
port. See the interfaces hybrid speed command for more information.
parameter default
auto | 10 | 100 | 1000 |
10000 | max 100 | max
1000}
Auto (copper ports);
1000 (fiber ports);
To Next Page
Loading...
