IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-65
ipv6 multicast spoofing
Enables or disables MLD spoofing on the specified VLAN or on the system if no VLAN is specified.
ipv6 multicast [vlan vid] spoofing [{enable | disable}]
no ipv6 multicast [vlan vid] spoofing
Syntax Definitions
vid VLAN on which to apply the configuration.
enable Enable MLD spoofing.
disable Disable MLD spoofing.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove an MLD spoofing entry on the specified VLAN or on the
system and return to its default behavior.
• If the MLD spoofing is already enabled on the system, then the VLAN configuration will override the
system's configuration.
• MLD spoofing refers to replacing a client's MAC and IP address with the system's MAC and IP
address when proxying aggregated MLD group membership information.
• You can also restore the MLD spoofing to its default (i.e., disabled) setting on the system if no VLAN
is specified, by using only ipv6 multicast spoofing (i.e., ipv6 multicast spoofing).
• You can also restore the MLD spoofing to its default (i.e., disabled) setting on the specified VLAN, by
using only ipv6 multicast vlan vid spoofing (i.e., ipv6 multicast vlan 2 spoofing).
Examples
-> ipv6 multicast spoofing enable
-> ipv6 multicast spoofing disable
-> ipv6 multicast spoofing
-> ipv6 multicast vlan 2 spoofing enable
-> ipv6 multicast vlan 2 spoofing disable
-> ipv6 multicast vlan 2 spoofing
-> no ipv6 multicast vlan 2 spoofing
parameter defaults
enable | disable disable
To Next Page
Loading...
