QoS Commands
page 38-66 OmniSwitch CLI Reference Guide November 2009
show qos statistics
Displays statistics about the QoS configuration.
show qos statistics
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command displays statistics about the global QoS configuration. Use the show qos config command
to display information about configurable global parameters.
Examples
-> show qos statistics
QoS stats
Events Matches Drops
L2 : 15 0 0
L3 Inbound : 0 0 0
L3 Outbound : 0 0 0
IGMP Join : 0 0 0
Fragments : 0
Bad Fragments : 0
Unknown Fragments : 0
Sent NI messages : 9
Received NI messages : 4322
Failed NI messages : 0
Load balanced flows : 0
Reflexive flows : 0
Reflexive correction : 0
Flow lookups : 0
Flow hits : 0
Max PTree nodes : 0
Max PTree depth : 0
Spoofed Events : 0
NonSpoofed Events : 0
DropServices : 0
output definitions
Events The number of Layer 2 or Layer 3 flows transmitted on the switch.
Matches The number of Layer 2 or Layer 3 flows that match policies.
To Next Page
Loading...
