QoS Policy Commands
OmniSwitch CLI Reference Guide November 2009 page 39-97
policy condition destination vlan
Configures a destination VLAN for a policy condition. Note that this condition is supported only in
combination with a multicast condition (multicast ip, multicast ipv6, or multicast network group).
policy condition condition_name destination vlan vlan_id
policy condition condition_name no destination vlan
Syntax Definitions
condition_name The name of the condition. May be an existing condition name or a new
condition.
vlan_id The destination VLAN ID for the flow.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a destination VLAN from a condition; however, at least
one classification parameter must be associated with a condition.
• Note that this condition is supported for multicast only policies.
Examples
-> policy condition cond4 destination vlan 3 multicast ip any
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply Applies configured QoS and policy settings to the current configuration.
policy condition Creates a policy condition.
show policy condition Shows information about policy conditions configured on the switch.
To Next Page
Loading...
