Chassis Management and Monitoring Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 2-57
show stack mode
Displays the current stacking or standalone mode of the switch.
show stack mode
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> show stack mode
NI Role State Running Saved
Mode Mode
----+-----------+--------+----------+---------------
1 PRIMARY RUNNING stackable stackable
2 SECONDARY RUNNING stackable stackable
output definitions
NI The current slot position for each switch in the virtual chassis (i.e.,
stacked configuration). Note that the order of the slot numbers does not
necessarily correspond with the physical positions of switches within
the stack. In other words, slot position 1 may not be the uppermost (top)
switch in the stack. To manually assign these slot numbers via the CLI,
use the stack set slot command.
Role The current management role of the corresponding switch:
PRIMARY (the switch is the primary management module in the stack;
standalone switches also display this role)
SECONDARY (the switch is the secondary—or backup—management
module in the stack)
To Next Page
Loading...
