802.1AB Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 13-13
lldp tlv dot1
Specifies the switch to control per port 802.1 TLVs to be incorporated in the LLDPDUs.
lldp {slot/port | slot | chassis} tlv dot1 {port-vlan | vlan-name} {enable | disable}
Syntax Definitions
slot/port Slot number for the module and physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
slot The slot number for a specific module.
port-vlan Enables or disables transmission of port VLAN TLV in LLDPDU.
vlan-name Enables or disables transmission of VLAN name TLV in LLDPDU.
enable Enables 802.1 TLV LLDPDU transmission.
disable Disables 802.1 TLV LLDPDU transmission.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The LLDPDU must be enabled and set to transmit before using this command.
• If this command is applied to a slot or chassis, then the existing configuration related to this command
will be lost.
• If one TLV is included then the other TLV is automatically included when you use this command.
Examples
-> lldp 5/1 tlv dot1 port-vlan enable
-> lldp 3 tlv dot1 vlan-name enable
-> lldp 3 tlv dot1 vlan-name disable
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable disable
To Next Page
Loading...
