QoS Commands
page 38-30 OmniSwitch CLI Reference Guide November 2009
qos revert
Deletes any QoS configuration that has not been applied to the configuration through the qos apply
command.
qos revert
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use this command to remove currently configured policies that have not yet been activated through the
qos apply command.
Examples
-> qos revert
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaQoSConfigTable
alaQoSConfigRevert
policy rule Configures a policy rule and saves it to the current configuration but
does not make it active on the switch.
qos apply Applies all QoS settings configured on the switch to the current configu-
ration.
qos reset Resets the QoS configuration to its defaults.
To Next Page
Loading...
