QoS Policy Commands
OmniSwitch CLI Reference Guide November 2009 page 39-21
policy service
Configures a service that may be used as part of a policy service group or included as part of a policy
condition. A service is a source and/or destination TCP or UDP port or port range.
This overview section describes the base command. At least one option must be configured with the base
command. Some options may be used in combination; some options are shortcuts for keyword combina-
tions (see the Usage Guidelines). Options are described as separate commands. See the command descrip-
tions and usage guidelines for valid combinations.
Use the no form for keywords to remove a parameter from a service.
policy service service_name
[protocol protocol]
[source ip port port[-port]]
[destination ip port port[-port]]
[source tcp port port[-port]]
[destination tcp port port[-port]]
[source udp port port[-port]]
[destination udp port port[-port]]
no policy service service_name
Syntax Definitions
service_name The name of the service (up to 31 alphanumeric characters).
protocol The protocol associated with the service. The range of values is 0–255.
Currently a value of 6 (for TCP) or 17 (for UDP) is supported. This
value must be specified for source ip port or destination ip port; it
cannot be specified for source tcp port, destination tcp port, source
udp port, or destination udp port.
port The well-known port number (or port range) for the desired service. For
example, the port number for Telnet is 23. Specify a range of ports
using a hyphen (for example, 22-23).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of the command to remove a service from the configuration, or to remove parameters
from a particular service. Note that at least one parameter must be associated with a service.
To Next Page
Loading...
