Alcatel-Lucent OmniSwitch 6250 - Show Snmp Station

SNMP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 10-5
show snmp station
Displays the current SNMP station status.
show snmp station
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> show snmp station
ipAddress/udpPort status protocol user
---------------------------------------------------+---------+--------+------
172.21.160.32/4000 enable v3 abc
172.21.160.12/5000 enable v3 user1
0300:0000:0000:0000:0211:d8ff:fe47:470b/4001 enable v3 user2
0300:0000:0000:0000:0211:d8ff:fe47:470c/5001 enable v2 abc
Release History
Release 6.6.1; command was introduced.
output definitions
IPAddress IP Address of the SNMP management station that replayed the trap.
UDP Port UDP port number.
Status The Enabled/Disabled status of the SNMP management station.
Protocol The version of SNMP set for this management station.
User The user account name.