QoS Commands
page 38-44 OmniSwitch CLI Reference Guide November 2009
qos port maximum egress-bandwidth
Configures the maximum rate at which to send traffic on the specified QoS port.
qos port slot/port maximum egress-bandwidth bps
qos port slot/port no maximum egress-bandwidth
Syntax Definitions
slot/port The slot number and port number of the physical port.
bps The maximum amount of bandwidth that may be used for all traffic
egressing on the QoS port.
Defaults
By default, the maximum bandwidth is the maximum allowed for the interface type on which the port
resides.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a configured maximum egress bandwidth value from a
port.
• When configuring the maximum egress bandwidth for a combo port, specify the bandwidth value in
multiples of 2Mbps.
• The maximum egress bandwidth value cannot exceed the maximum bandwidth of the interface type
associated with the port.
• Modifying the maximum egress bandwidth is most useful for low-bandwidth links.
Examples
-> qos port 3/1 maximum egress-bandwidth 1000
-> qos port 3/1 no maximum egress-bandwidth
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
