QoS Policy Commands
page 39-32 OmniSwitch CLI Reference Guide November 2009
policy service destination udp port
Configures a service with a destination UDP port or port range that may be used as part of a policy service
group or included as part of a policy condition.
policy service service_name destination udp port port[-port]
no policy service service_name
policy service service_name no destination udp port
Syntax Definitions
service_name The name of the service (up to 31 alphanumeric characters).
port The well-known port number (or port range) for the desired UDP
service. For example, a port number for NETBIOS is 137. A port range
should be separated by a hyphen (for example, 137-138).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command is a shortcut for the policy service protocol command.
• A policy service may be grouped in a policy group using the policy service group command. A policy
condition may then be associated with the service group.
• Use the no form of the command to remove a service from the configuration, or to remove parameters
from a particular service.
• If the snapshot command is entered after the policy service command is configured, the resulting
ASCII file will include the following additional syntax for the policy service command:
from {cli | ldap | blt}
This syntax indicates how the service was created. The cli and ldap options may be changed by a user
modifying the ASCII file; however, changing this setting is not recommended. The blt option indicates
a built-in object, this setting is not configurable.
Examples
-> policy service service4 destination udp port 137
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
