CMM Commands
page 1-10 OmniSwitch 6250 CLI Reference Guide November 2009
copy working certified
Copies the working directory version of the CMM software to the certified directory, on the primary
CMM. This command also allows you to synchronize the primary and secondary CMMs.
[configure] copy working certified [flash-synchro]
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command is used to overwrite the contents of the certified directory with the contents of the work-
ing directory. This should only be done if the contents of the working directory have been verified as
the best version of the CMM files.
• The flash-synchro keyword, when used with the copy certified working command, synchronizes the
files between the primary and secondary CMMs by overwriting the contents of the secondary CMM
certified directory with the contents of the primary CMM certified directory. If the switch is part of a
stacked configuration, all switches in the stack are updated with the primary CMM files.
• In order for this command to work, the amount of free space in flash must equal the size of the files
being copied. If there isn’t enough free space, the copy attempt will fail and an error message is gener-
ated. Only image files, the boot.cfg file, and the certs.pem file should be kept in the working directory.
• This command will not work if the switch is running from the certified directory. To view where the
switch is running from, see the show running-directory command.
Examples
-> copy working certified
-> copy working certified flash-synchro
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
