Configuration File Manager Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 9-11
configuration snapshot
Generates a snapshot file of the switch’s non-default current running configuration. A snapshot can be
generated for all current network features or for one or more specific network features. A snapshot is a
single text file that can be viewed, edited, and reused as a configuration file.
configuration snapshot feature_list [path/filename]
Syntax Definitions
feature_list The description for the network feature(s) to be included in the
snapshot. You may enter more than one network feature in the
command line. Current snapshot-supported network features are listed
below.
path/filename A user-defined name for the resulting snapshot file. For example,
test_snmp_snap. You may also enter a specific path for the resulting
file. For example, the syntax /flash/working/test_snmp_snap places
the test_snmp_snap file in the switch’s /flash/working directory.
Defaults
If a file name is not specified, the default file name asc.#.snap is used. Here, # indicates the order in
which the default file is generated. For example, the first default file name to be generated is asc.1.snap,
the second default file name to be generated is named asc.2.snap, etc. By default, all snapshot files are
placed in the root /flash directory.
Platforms Supported
OmniSwitch 6250
snapshot-supported features
802.1q ip-helper policy
aaa ip-routing qos
aip ipmr rdp
all ipms rip
bridge ipv6 ripng
chassis linkagg session
efm-oam loopback-detection snmp
ethernet-oam module stack-manager
health ntp stp
interface port-mapping vlan
ip pmm
To Next Page
Loading...
