Alcatel-Lucent OmniSwitch 6250 - Who

Session Management Commands
page 6-30 OmniSwitch 6250 CLI Reference Guide November 2009
who
Displays all active login sessions (e.g., Console, Telnet, FTP, HTTP, Secure Shell, and Secure Shell FTP).
who
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
You can identify your current login session by using IP address.
Examples
-> who
Session number = 0
User name = (at login),
Access type = console,
Access port = Local,
IP address = 0.0.0.0,
Read-only domains = None,
Read-only families = ,
Read-Write domains = None,
Read-Write families = ,
End-User profile =
Session number = 5
User name = admin,
Access type = telnet,
Access port = NI,
IP address = 128.251.17.176,
Read-only domains = None,
Read-only families = ,
Read-Write domains = All ,
Read-Write families = ,
End-User profile =
output definitions
Session Number The session number assigned to the user.
User name User name.
Access type Type of access protocol used to connect to the switch.
Access port Switch port used for access during this session.