Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-73
show interfaces hybrid flow control
Displays interface flow control wait time settings for combo ports.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} flow control
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
fiber Specifies that the configuration of the SFP port(s) will be displayed.
copper Specifies that the configuration of the copper RJ-45 port(s) will be
displayed.
Defaults
If a specific slot or slot/port number is not entered with this command, the flow control wait tme settings
for all switch combo ports is displayed..
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the slot, slot/port, or slot/port-port2 parameters to display the flow control wait time settings for all
ports on a slot, a specific port, or for a range of ports.
Examples
-> show interfaces hybrid fiber flow control
Slot/Port Active Wait time(usec) Cfg-Flow Cfg-Cross
-----------+--------+---------------+--------+-----------
1/25 - 0 Pause MDI
1/26 - 0 Pause MDI
output definitions
Slot/Port Interface slot and port number
Active Interface status.
Wait time Flow control wait time, in microseconds.
Cfg-Flow Flow control status, which can be Pause or Go.
Cfg-Cross The user-configured cross-over setting, which can be Auto, MDI, or
MDIX.
To Next Page
Loading...
