Loopback Detection Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 17-9
show loopback-detection port
Displays global LBD configuration information on the switch. When slot and port number is mentioned,
the LBD configuration information of the specific port is displayed.
show loopback-detection port [slot/port]
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
• Use this command to view LBD information of a specific port on a switch.
Examples
-> show loopback-detection port
Slot/Port Admin State OperState
-------------+---------------+-----------------
1/2 enabled Normal
-> show loopback-detection port 1/1
Global LBD Status : Enabled
Global LBD Transmission Timer : 200 sec
Global LBD Transmission Timer : 300 sec
Port LBD Status : Enabled
Port LBD State : Normal
output definitions
Global LBD Status The current status of LBD of the switch (Enabled or Disabled).
Globas LBD Transmission
Timer
Displays the time interval in seconds between LBD packet transmis-
sions.
Global LBD Auto-recovery
Timer
Displays the autorecovery time period in seconds. It is the time period
that passes after which ports that were shut down through LBD are
moved to normal state.
Slot/Port The slot/port number LBD port.
Admin State The administrative state of the port (Enabled or Disabled).
Oper State The operational state of the port (Normal or Inactive).
To Next Page
Loading...
