Alcatel-Lucent OmniSwitch 6250 - Lacp Linkagg Actor System ID

Link Aggregation Commands
page 12-16 OmniSwitch 6250 CLI Reference Guide November 2009
lacp linkagg actor system id
Configures the MAC address of a dynamic aggregate group on the switch.
lacp linkagg agg_num actor system id actor_system_id
lacp linkagg agg_num no actor system id
Syntax Definitions
agg_num The number corresponding to the dynamic aggregate group.
actor_system_id The MAC address of the dynamic aggregate group on the switch in the
hexadecimal format xx:xx:xx:xx:xx:xx.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the no form of this command to remove an actor system ID from a dynamic aggregate group.
Examples
-> lacp linkagg 3 actor system id 00:20:da:81:d5:b0
-> lacp linkagg 3 no actor system id
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alclnkaggAggTable
alclnkaggAggNumber
alclnkaggAggActorSystemID
parameter default
actor_system_id 0
lacp linkagg size Creates a dynamic aggregate group.
show linkagg Displays information about static and dynamic (LACP) aggregate
groups.