Link Aggregation Commands
page 12-26 OmniSwitch 6250 CLI Reference Guide November 2009
lacp agg actor system id
Configures the system ID (i.e., MAC address) for the local port associated with a dynamic aggregate
group.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port actor system id actor_system_id
lacp agg [ethernet | fastethernet | gigaethernet] slot/port no actor system id
Syntax Definitions
ethernet Documents that the port is 10 Mbps Ethernet.
fastethernet Documents that the port is 100 Mbps Fast Ethernet.
gigaethernet Documents that the port is Gigabit Ethernet.
slot The slot number for this aggregate.
port The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
actor_system_id The MAC address of the dynamic aggregate group on the switch in the
hexadecimal format xx:xx:xx:xx:xx:xx.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove an actor system ID from a slot and port associated with a
dynamic aggregate group.
• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
Chapter 20, “Ethernet Port Commands,” for information on CLI commands to configure Ethernet ports.
Examples
-> lacp 3/1 actor system id 00:20:da:06:ba:d3
-> lacp 3/1 no actor system id
Release History
Release 6.6.1; command was introduced.
parameter default
actor_system_id 0
To Next Page
Loading...
