Link Aggregation Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 12-25
cates that the actor is using the defaulted partner information adminis-
tratively configured for the partner.
expire Specifying that this keyword has no effect because the system always
determines its value. When this bit (bit 7) is set by the system, the actor
cannot receive LACPDU frames.
none Resets all administrative states to their default configurations.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to restore the LACPDU bit settings to their default configuration.
• When the actor admin state is set to none, all bit values are restored to their default configurations.
• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
Chapter 20, “Ethernet Port Commands,” for information on CLI commands to configure Ethernet
ports.
Examples
-> lacp agg 4/2 actor admin state synchronize no collect distribute
-> lacp agg 4/2 actor admin state no synchronize collect
-> lacp agg 4/2 actor admin state none
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alclnkaggAggPortTable
alclnkaggAggPortGlobalPortNumber
alclnkaggAggPortActorAdminState
parameter default
[active] [timeout] .... active, timeout, aggregate
lacp linkagg size Creates a dynamic aggregate group.
show linkagg port Displays information about ports associated with a particular aggregate
group or all aggregate groups.
To Next Page
Loading...
