RIP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 33-15
ip rip host-route
Specifies whether or not RIP can add host routes (routes with a 32-bit mask) to the RIP table.
ip rip host-route
no ip rip host-route
Syntax Definitions
N/A
Defaults
The default is to enable a default host route.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to prevent RIP from adding host routes to the RIP table.
• When enabled, RIPv1 will interpret an incoming route announcement that contains any 1 bit in the host
portion of the IP address as a host route, implying a mask of 255.255.255.255.
Examples
-> ip rip host-route
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaProtocolRip
alaRipHostRouteSupport
show ip rip routes Displays the RIP Routing Database.
To Next Page
Loading...
