VLAN Stacking Commands
OmniSwitch CLI Reference Guide November 2009 page 24-35
show ethernet-service sap
Displays configuration information for VLAN Stacking Service Access Points (SAP).
show ethernet-services sap [sapid]
Syntax Definitions
sapid The SAP ID number identifying the service instance.
Defaults
By default, all SAPs are displayed if a SAP ID is not specified with this command.
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
Specify a single SAP ID to display configuration information for a specific SAP.
Examples
-> show ethernet-services sap
SAP Id : 10
UNIs : 2/10, 2/11
CVLAN(s) : 500, 600
sap-profile : default-sap-profile
SAP Id : 20
UNIs : 1/1, 1/2
CVLAN(s) : 10, 20
sap-profile : sap-video1
SAP Id : 30
UNIs : 1/3
CVLAN(s) : 30, 40
sap-profile : sap-video2
-> show ethernet-service sap 10
SAP Id : 10
UNIs : 2/10, 2/11
CVLAN(s) : 500, 600
sap-profile : default-sap-profile
To Next Page
Loading...
