Link Aggregation Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 12-15
lacp linkagg actor system priority
Configures the priority of the dynamic aggregate group.
lacp linkagg agg_num actor system priority actor_system_priority
lacp linkagg agg_num no actor system priority
Syntax Definitions
agg_num The number corresponding to the link aggregate group.
actor_system_priority The priority of the switch’s dynamic aggregate group in relation to other
aggregate groups. Possible values are 0–65535.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to return the value to its default.
• Ports with the same system priority value can join the same dynamic aggregate group.
Examples
-> lacp linkagg 3 actor system priority 100
-> lacp linkagg 3 no actor system priority
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alclnkaggAggTable
alclnkaggAggNumber
alclnkaggAggActorSystemPriority
parameter default
actor_system_priority 0
lacp linkagg size Creates a dynamic aggregate group.
show linkagg Displays information about static and dynamic (LACP) aggregate
groups.
To Next Page
Loading...
