OmniSwitch 6250 CLI Reference Guide November 2009 page 35-1
35 RMON Commands
Remote Network Monitoring (RMON) probes can be used to monitor, manage, and compile statistical data
about network traffic from designated active ports in a LAN segment without negatively impacting
network performance. This feature supports basic RMON 4 group implementation compliant with
RFC 2819 (Remote Network Monitoring Management Information Base), but does not support RMON 10
group or RMON 2. This chapter includes descriptions of RMON
commands used to enable or disable indi-
vidual (or a group of a certain flavor type) RMON probes, show a list of (or individual) RMON
probes and
show a list of (or individual) RMON
logged events.
MIB information for the RMON commands is as follows:
Filename: IETF_RMON.mib
Module: RMON-MIB
The following table summarizes the available commands:
rmon probes
show rmon probes
show rmon events
To Next Page
Loading...
